Xilinx ZC702 Getting Started Manual

Also see for ZC702: Quick start guide Quick start guide Getting started guide User guide User guide

ZC702 and ZVIK Getting Started Guide www.xilinx.com 41UG926 (v3.0.1) February 12, 2013Running the Video Demonstration for 720p Video ResolutionSobel Filter Modes are explained as follows:Sobel OFF• No processing done. Sobel filter is bypassed.Sobel – SW• Video processing (edge-detection filter) done by software code running on PSSobel On – HW• Video processing (edge-detection filter) done by PLFigure 3-8 shows the detected image edges of the video generated by the TPG, that is,case 1 versus case 2 or 3 of Table 3-2.3. Enter 0 to exit the application and return to the command prompt.Running the Video Demonstration for 720p VideoResolutionCopy the devicetree720p.dtb binary file (provided with the binary package) and save itas devicetree.dtb in the SD MMC root, overwriting the old devicetree.dtb.Configure the display monitor to 720p60 resolution: 1280 x 720p @ 60 Hz. If using the ZVIKwith an external video source, configure the external video source to 1280 x 720 @ 60 Hz.Note: To restore the design to support 1080P60 again, copy the file devicetree1080P.dtb andsave it as devicetree.dtb on the SD MMC root, overwriting the old devicetree.dtb.• Follow the steps in Running the Qt-Based GUI Application Demonstration, page 34 torun the Qt-based GUI application demonstration.• Follow the steps in Running the UART Menu-Based Demonstration Application, page 39to run the menu-based application demonstration.For additional example designs, tutorials, software, and other information related tothe ZVIK, please refer to Next Steps for the Zynq-7000 AP SoC Video and Imaging Kit(ZVIK), page 47.