Wi-Fi Array194 Configuring the Wi-Fi ArrayTime Settings (NTP)This window allows you to manage the Array’s time settings, includingsynchronizing the Array’s clock with a universal clock from an NTP (NetworkTime Protocol) server. Synchronizing the Array’s clock with an NTP serverensures that Syslog time-stamping is maintained across all units.Figure 113. Time Settings (Manual Time)Procedure for Managing the Time Settings1. Time Zone: Select the time zone you want to use (normally your localtime zone) from the pull-down list.2. Auto Adjust Daylight Savings: Check this box if you want the system toadjust for daylight savings automatically, otherwise leave this boxunchecked (default).3. Use Network Time Protocol: select whether to set time manually or useNTP to manage system time.4. Setting Time Manuallya. Adjust Time (hrs:min:sec): If you are not using NTP, check this box ifyou want to adjust the current system time. When the box is checked,the time fields become active. Enter the revised time (hours, minutes,seconds, am/pm) in the corresponding fields. If you don’t want toadjust the current time, this box should be left unchecked (default).
