Wireless LAN ArrayInstalling the Xirrus Array 21Installing the Xirrus ArrayThis chapter defines the prerequisites for installing the Xirrus Array and providesinstructions to help you complete a successful installation. Section headings forthis chapter include:z “Installation Prerequisites” on page 21z “Planning Your Installation” on page 24z “Installation Workflow” on page 39z “Unpacking the Xirrus Array” on page 40z “Installing Your Xirrus Wireless LAN Array” on page 41z “Powering Up the Xirrus Wireless LAN Array” on page 51z “Establishing Communication with the Array” on page 53z “Performing the Express Setup Procedure” on page 54Installation PrerequisitesYour Xirrus Array deployment requires the presence of hardware and services inthe host wired/wireless network, including:z Dedicated AC power outletUnless you are using the Xirrus Remote DC Power System (XP-3100) withthe DC version of the Xirrus Array, you need a dedicated power outlet tosupply AC power to each unit deployed at the site. If you are using theoptional XP-3100, then DC power is supplied to all units and only one ACoutlet is required for the XP-3100.z Ethernet port (read notes)You need at least one 10/100/1000 BaseT port to establish wired GigabitEthernet connectivity (via the product’s Gigabit 1 or Gigabit 2 port) andone 10/100 BaseT port (if desired) for product management.! The Array’s Ethernet ports should be plugged into an Ethernet switch, notan Ethernet hub—if a hub is used, we recommend that you connect onlyone Ethernet port.
