YASKAWA 1000 Series Installation Manual

Also see for 1000 Series: Installation manual Installation manual Installation manual Installation manual Installation manual

Contents

6 Related Parameters28 YASKAWA ELECTRIC TOBP C730600 42D 1000-Series Option SI-P3 Installation ManualF7-78(792)<3> <7>PZD9 ReadSets MEMOBUS/Modbus address for PZD9 Read(PPO Read).The value of 0 to 2 disables the PZD9 Read.Default: 0HMin: 0HMax: FFFFHF7-79(793)<3> <7>PZD10 ReadSets MEMOBUS/Modbus address for PZD10 Read(PPO Read).The value of 0 to 2 disables the PZD10 Read.Default: 0HMin: 0HMax: FFFFH<1> Set b1-02 to 3 to start and stop the drive through the PROFIBUS-DP network. Set b1-01 to 3 to control thefrequency reference of the drive via the PROFIBUS-DP network.<2> Take proper safety measures, such as installing an emergency stop switch, when setting F6-03 to 3 or 4, as thedrive will continue operation when detecting a fault.<3> Available in the A1000 software versions PRG: 1021 and later.<4> Refer to the instruction manual of a specific drive to determine if settings 4 and 5 are available in the drive.<5> Enabled in CLV, AOLV/PM, and CLV/PM control modes (A1-02 = 3, 6, or 7). When enabled, d5-01 determineswhether the value is read as the torque limit value (d5-01 = 0) or as the torque reference value (d5-01 = 1). InCLV/PM, this value is read as the torque limit.<6> Default setting specifies that the torque reference or torque limit is to be provided via network communications(F6-06 = 1). The motor may not rotate if no torque reference or torque limit is supplied from the PLC.<7> Available in the option software versions PRG: 2103 and later.<8> All node addresses must be unique. Node addresses 0, 1, and 2 are typically reserved for control, maintenance,and diagnostic equipment. The “Err” LED will illuminate when a value of 0 or a value greater than 125 is entered.<9> Cycle power for setting changes to take effect.<10> Requires also setting bit 0 to 1 to issue Run command. Refer to the option Technical Manual for moreinformation.<11> When writing this parameter to the drive through the PROFIBUS-DP network, the parameter is validated byautomatically executing the Enter command.No.(Addr. Hex) Name Description Values