5 Replacing Parts5.4 FS100 Replacement5-14159645-1CDRE-CHO-A111FS1005.4.4 Loading the Backup DataTo the replaced FS100, load the backup data (CMOS.BIN) that was savedbefore the replacement.Perform the backup by CMOS.BIN in the maintenance mode.The chart below shows the availability of CMOS save and CMOS load ineach security mode in the maintenance mode. Follow the procedures below to load CMOS.BIN.While pressing the main menu key , turn ON the FS100 power supply.8. Change the security mode to the maintenance mode.9. Insert a CompactFlash card into the CompactFlash slot on theprogramming pendant.– When using USB memory instead of CompactFlash, mount a USBmemory stick to the programming pendant, select {DEVICE}, thenselect ”USB: PENDANT”.To connect a USB memory stick to the USB device of the main CPUboard, mount a USB memory stick to the USB device, select{DEVICE}, then select ”USB: CONTROLLER”.10. Select {EX. MEMORY} under the main menu.– The sub menu appears.Security CMOS Save CMOS LoadOperation Mode Not available Not availableEditing Mode Available Not availableManagement Mode Available AvailableYASKAWA Mode Available AvailableMAINMENU50 of 348
