YASKAWA SI-EP3 Installation Manual

Also see for SI-EP3: Technical manual Technical manual Technical manual Installation manual

Contents

YASKAWA ELECTRIC TOBP C730600 89D YASKAWA AC Drive Option SI-EP3 Installation Manual 133 Receiving3 ReceivingAfter receiving the option package:1. Make sure that the option is not damaged and no parts are missing. Contact your salesoutlet if the option or other parts appear damaged.NOTICE: Do not use damaged parts to connect the drive and the option. Failure to comply could damagethe drive and option.2. Confirm that the model number on the option nameplate and the model listed in thepurchase order are the same. Refer to Figure 2 on page 14 for details. Contact thedistributor where the option was purchased or contact Yaskawa or a Yaskawarepresentative about any problems with the option.u Option Package ContentsTable 2 Option Package Contentsu Installation Tools• A Phillips screwdriver. Phillips screw sizes vary by drive capacity.• A flat-blade screwdriver (blade depth: 0.4 mm (0.02 in), width: 2.5 mm (0.1 in)).• A pair of diagonal cutting pliers.• A small file or medium-grit sandpaper.Description:<1> GA700 and GA800 drives do not use the ground wire.<2> GA700 and GA800 drives use two screws only.Option GroundWire <1>Screws(M3)LED LabelsInstallationManual1000-SeriesGA500,GA700, andGA800_Quantity: 1 1 3 <2> 1 1 1NS MS MANUAL