YASKAWA SI-N3 Installation Manual

Also see for DeviceNet SI-N3: Technical manual Technical manual Installation manual Technical manual Installation manual

Contents

5 Installation ProcedureYASKAWA ELECTRIC TOBP C730600 84D YASKAWA AC Drive Option SI-N3 Installation Manual 274. Insert the option card (B) into the CN5-A connector (I) on the drive and fasten it intoplace using the included screws (C). Tighten both screws to 0.5 to 0.6 Nm (4.4 to5.3 inlb).Note: Installing the option card on GA700 and GA800 drives requires only two screws and does notrequire a ground wire. The option package ships with three screws and a ground wire forinstallation on other product series. Do not use the ground wire or the extra screw.Figure 14Figure 14 Insert the Option Card5. Firmly connect the DeviceNet communication cable to option terminal block(CN1).Install DeviceNet communications cables apart from main-circuit wiring and otherelectrical and power lines. Ensure the cable end is firmly connected (seeFigure 16). Refer to Communication Cable Topology on page 29 for details.Note: Maximum transmission distance is 100 m (328 ft). Minimum wiring distance between stations is0.2 m (7.9 in).ICBA1000