YASKAWA SI-N3 Installation Manual

Also see for DeviceNet SI-N3: Technical manual Technical manual Installation manual Technical manual Installation manual

Contents

6 Related ParametersYASKAWA ELECTRIC TOBP C730600 84D YASKAWA AC Drive Option SI-N3 Installation Manual 33F6-07(03A8)MultiStep Ref PrioritySelect0: MultiStep References Disabled1: MultiStep References EnabledDefault: 0Range: 0, 1F6-08(036A)Comm Parameter Reset@InitializeSelects whether communication-related parameters F6-and F7- are set back to original default values when thedrive is initialized using parameter A1-03.0: No Reset - Parameters retained1: Reset - Back to factory defaultNote: The setting value is not changed even when F6-08 isset to 1 and the drive is initialized using A1-03.Default: 0Range: 0, 1F6-15(0B5B)<7>Comm. OptionParameters ReloadSelects whether F6-/F7- communication-relatedparameters changed are enabled.0: Reload at Next Power Cycle1: Reload Now2: Cancel Reload RequestNote: F6-15 is reset to 0 after setting 1 or 2.Default: 0Range: 0 to 2F6-50(03C1)<8> <9>DN MAC Address Selects the drive MAC addressNote: Used in the DeviceNet ObjectDefault: 0 <10>Min: 0Max: 64F6-51(03C2)<9>DN Baud RateDeviceNet communication speed0: 125 kbps1: 250 kbps2: 500 kbps3: Adjustable from network4: Detect automaticallyNote: Used in the DeviceNet ObjectDefault: 0 <10>Range: 0 to 4F6-52(03C3)<11>DeviceNet PCA Setting I/O Polled Consuming Assembly data instanceNote: Used in the Connection ObjectDefault: 21Min: 0Max: 255F6-53(03C4)<11>DeviceNet PPA Setting I/O Polled Producing Assembly data instanceNote: Used in the Connection ObjectDefault: 71Min: 0Max: 255F6-54(03C5)<9>DN Idle Flt DetDetermines what the drive should do when communicationgoes into idle mode.0: Stop, drive will stop1: Ignore, drive will continue what it was doing2: Vendor Specific, drive will use to F6-01 to determinewhether it should stop or continue3: Run Fwd, the drive will run in the forward direction4: Run Rev, the drive will run in the reverse directionDefault: 0Range: 0 to 4F6-55(03C6) DN BAUD RATE MEMDisplays the baud rate currently being used for networkcommunications. F6-55 is used only as a monitor.0: 125 kbps1: 250 kbps2: 500 kbpsNote: Used in the DeviceNet ObjectDefault: 0Range: 0 to 2No.(Hex.) Name Description Values