3.3 CablingCAUTION!– The power supplies must be released before installation and repairtasks, i.e. before handling with the power supply or with the cablingyou must disconnect current/voltage (pull plug, at fixed connectionswitch off the concerning fuse)!– Installation and modifications only by properly trained personnel!For the cabling of power supply of a CPU, a green plug with CageClamp technology isdeployed. The connection clamp is realized as plug that may be clipped off carefully if it isstill cabled.Here wires with a cross-section of 0.08mm2 to 2.5mm2 may be connected. You can useflexible wires without end case as well as stiff wires.1 Test point for 2mm test tip2 Locking (orange) for screwdriver3 Round opening for wiresThe picture on the left side shows the cabling step by step from top view.1. For cabling you push the locking vertical to the inside with a suiting screwdriver andhold the screwdriver in this position.2. Insert the de-isolated wire into the round opening. You may use wires with a cross-section from 0.08mm2 to 2.5mm23. By removing the screwdriver the wire is connected safely with the plug connectorvia a spring.CageClamp technology(green)VIPA System 300S+ Assembly and installation guidelinesCablingHB140 | CPU-SC | 313-5BF23 | en | 19-01 21
