Link CX-24 User’s ManualVersion 1.0 Page 29 February 2004Figure 2.11 – Typical Link CX-24 DS-3 Test Web Page2.10.4 Testing an Ethernet Link CX-2421 Connect an external Ethernet device to the ETHERNET 1 or 2 port on the Link CX-24.22 Use the external Ethernet device to Ping the Link CX-24 at the local Ethernet address configured inStep 12. Verify that the Link CX-24 responds to the Ping. When the Ping test is complete, the LinkCX-24 has been configured, and the internal Ethernet circuitry of the Link CX-24 has been tested.23 Disconnect the external Ethernet device from the Link CX-24.24 Continue with Step 25.Note: Do not stand within 2 m (79 in.) of the front of the antenna for prolonged periods during LinkCX-24 operation to avoid harmful RF radiation.25 On the Commission Radio page, set the Tx Attenuation to disabled. This causes the Link CX-24 totransmit at the level set by the Maximum Transmit Power parameter.26 Disconnect power from the Link CX-24 to prepare it for mounting in its final location.27 Disconnect the Craft PC from the Link CX-24.
