Link CX-24 User’s ManualVersion 1.0 Page 32 February 2004Figure 2.14 – Detail Showing Assembly of Pole Mounting Bracket to Unit (Vertical Polarization)2.11.2 Attaching the Link CX-24 to the Pole30 Attach the Link CX-24 to the pole as described below:a) Fasten the Link CX-24 unit to the pole using pole clamp (B) and two M8 x 70 bolts, lock washer,and flat washer, as shown in Fig 2.15. It may be necessary to use two M8 x 40L bolts if you arefastening the Link CX-24 to a 1.75” diameter pole. Do not tighten at this stage. The pole-mounting bracket (A) will accept pole diameters between 1.75” to 3” OD. The Link CX-24 unitcan be mounted to larger pole diameters by discarding pole clamp (B) and replacing it withmetal straps (not included) fastened through slots located on the pole-mounting bracket (A).b) Finger-tighten the two bolts on the clamp (B). The Link CX-24 mounting bracket assemblyshould be able to pivot around the pole and elevate up and down, allowing fine azimuth andelevation alignment. Use a compass or optical aid to coarsely align the assembly between thefar-end antenna locationsSerratedEdgesXANotepolarization
