1. Changes or modifications to this device not expressly approved by VERTEXSTANDARD could void the user’s authorization to operate this device.2. This device complies with part 15 of the FCC Rules. Operation is subject to thefollowing two conditions; (1) this device may not cause harmful interference, and (2)this device must accept any interference including interference that may causeundesired operation.3. The scanning receiver in this equipment is incapable of tuning, or readily beingaltered, by the User to operate within the frequency bands allocated to the Domesticpublic Cellular Telecommunications Service in Part 22.DECLARATION BY MANUFACTURERThe scanner receiver is not a digital scanner and is incapable of being converted ormodified a digital scanner receiver by any user.W A R N I N G : M O D I F I C A T I O N O F T H I S D E V I C E T O R E C E I V E C E L L U L A RRADIOTELEPHONE SERVICE SIGNALS IS PROHIBITED UNDER FCC RULES ANDFEDERAL LAW.This equipment has been tested and found to comply with the limits for a Class B digitaldevice, pursuant to Part 15 of the FCC Rules. These limits are designed to providereasonable protection against harmful interference in a residential installation. Thisequipment generates, uses and can radiate radio frequency energy and, if not installedand used in accordance with the instructions, may cause harmful interference to radiocommunications. However, there is no guarantee that interference will not occur in aparticular installation.If this equipment does cause harmful interference to radio or television reception, whichcan be determined by turning the equipment off and on, the user is encouraged to try tocorrect the interference by one or more of the following measures:-- Reorient or relocate the receiving antenna.-- Increase the separation between the equipment and receiver.-- Connect the equipment into an outlet on a circuit different from that to which thereceiver is connected.-- Consult the dealer or an experienced radio/TV technician for help.