39FT-7900R OPERATING MANUALMemory Bank Recall1. Set the radio to the Memory mode by pressing the [V/M(MW)] key, if necessary.2. Press and hold in the [SCAN(SEL)] key for 1/2 sec-ond, then rotate the DIAL knob to select the MemoryBank (“BANK 1BANK 1BANK 1BANK 1BANK 1” ~ “BANK20BANK20BANK20BANK20BANK20”).3. Press the [BAND(SET)] key momentarily to lock in the selected Memory Bank.4. In the Memory Bank mode of operation, you can only select memory channels within thecurrent Memory Bank.5. To change the Memory Bank to another Bank, press and hold in the [SCAN(SEL)] keyfor 1/2 second; now rotate the DIAL knob to select the new Memory Bank, then press the[BAND(SET)] key momentarily to lock in the new Memory Bank.6. To exit from Memory Bank operation, press and hold inthe [SCAN(SEL)] key for 1/2 second, then rotate theDIAL knob to select “NOBANKNOBANKNOBANKNOBANKNOBANK;” now press the[BAND(SET)] key momentarily.Deleting a Memory Channel from a Memory Bank1. In the Memory Bank mode, recall the memory channel to be deleted from the MemoryBank.2. Press and hold in the [SCAN(SEL)] key for 1/2 second, then press and hold in the[V/M(MW)] key for 1/2 second. The channel will now be deleted from the MemoryBank, but the memory register itself will still be available in the non-Bank mode.Memory Only ModeOnce memory channel programming has been completed, you may place the radio in a“Memory Only” mode, whereby VFO operation is impossible. This may be particularlyuseful during public-service events where a number of operators may be using the radio forfirst time, and ultimate simplicity of channel selection is desired.To place the radio into the Memory Only mode:1. Turn the radio off.2. Press and hold in the [MHz(PRI)] key while turning the radio on.3. Rotate the DIAL knob to select the (F-6 M-ONLYF-6 M-ONLYF-6 M-ONLYF-6 M-ONLYF-6 M-ONLY) op-tion, then press and hold in the [BAND(SET)] key for1/2 second.To return to normal operation, repeat the above steps.M EMORY O PERATIONREGULAR MEMORY CHANNEL OPERATION