17Filter Function DisplayDisplays the passband status of the DSP filter. The operation of WIDTH, SHIFT, NOTCH, CONTOUR etc.can be observed.The current roofing filterbandwidth is displayed asa blue line below the filterfunction display.The roofing filter is select-ed by touching [R. FIL].Touch the filter function display to toggle between “normal display” and “magnified display”. Touch again to re-turn to the “normal display”.• Display only DSP filter bandwidth informationTo display only the DSP filter bandwidth information, press andhold the spectrum area of the filter function display to clear thespectrum view. To display it, press and hold again.Frequency DisplayThe transmit and receive frequencies of the MAIN Band are shown on the left and the transmit andreceive frequencies of the SUB Band are shown on the right.In split operation, the transmit frequency is displayed in red.• Keyboard Frequency Entry1. Touch the “Hz” area of the frequency display.2. Enter the frequency using the numeric keys.Clear all entered numbers.The entered frequency isconfirmed.The display returns to theprevious screen whenback is touched.Erases the rightmost digit.● If there is no operation within 10 seconds,the input will be canceled.3. Touch [ENT] to confirm.● A short-cut for frequencies ending in zero -press the [ENT] key after the last non-zerodigit.Example:To enter 7.00.000MHz[0] → [7] → [ENT] or [7] → [.] → [ENT]To enter 7.03.000MHz[7] → [.] → [0] → [3] → [ENT]• Tuning in 1 MHz or 1 kHz StepsTo temporarily set the dial knob to 1MHz or 1kHzsteps, touch the “MHz” or “kHz” area of the fre-quency display.Touch “MHz” or “kHz” area of the frequency dis-play to confirm. If there is no operation within 3seconds, the frequency will be fixed.• Touch the Frequency Display of the inactiveband to change the Operating Band with onetouch.• Touch the Scope Screen, to easily move tothe touched frequency.SSB ModeRoofing filter bandwidthDSP filter bandwidthCW Mode RTTY Mode PSK/DATA Mode