Yaesu FTDX101D Operation Manual

Also see for FTDX101D: Information for Customers Operating Information for Customers Operating Operation manual Technical supplement Manual

Contents

RPTT SELECTFunction: Sets the PTT control for the FM trans-mit signal.Available Values: DAKY / RTS / DTRDefault Setting: DAKYDescription:DAKY: Controls the FM transmit signal from theRTTY/DATA jack (pin 3) on the rear panel.DTR: Controls the FM transmit signal from theUSB virtual COM/DTR ports.RTS: Controls the FM transmit signal from theUSB virtual COM/RTS ports.RPT SHIFT(28MHz)Function: Sets the RPT offset frequency on the28 MHz band.Available Values: 0 - 1000 kHzDefault Setting: 100 kHzDescription: The RPT offset frequency can be setat 10 kHz increments between 0 kHzand 1000 kHz.RPT SHIFT(50MHz)Function: Sets the RPT offset frequency on the50 MHz band.Available Values: 0 - 4000 kHzDefault Setting: 1000kHzDescription: The RPT offset frequency can be setat 10 kHz increments between 0 kHzand 4000 kHz.RADIO SETTING- MODE PSK/DATA -AGC FAST DELAYFunction: Sets the AGC-FAST DELAY voltagedecay characteristics for PSK/DATAmode.Available Values: 20 - 4000msecDefault Setting: 160msecDescription: Sets the AGC voltage decay char-acteristics in 20 msec steps afterthe input signal level becomes lowerthan the AGC detection level and theHOLD time has expired.AGC MID DELAYFunction: Sets the AGC-MID DELAY voltagedecay characteristics for PSK/DATAmode.Available Values: 20 - 4000msecDefault Setting: 500msecDescription: Sets the AGC voltage decay char-acteristics in 20 msec steps afterthe input signal level becomes lowerthan the AGC detection level and theHOLD time has expired.AGC SLOW DELAYFunction: Sets the AGC-SLOW DELAY voltagedecay characteristics for PSK/DATAmode.Available Values: 20 - 4000msecDefault Setting: 1500msecDescription: Sets the AGC voltage decay char-acteristics in 20 msec steps afterthe input signal level becomes lowerthan the AGC detection level and theHOLD time has expired.PSK TONEFunction: Set the PSK toneAvailable Values: 1000 / 1500 / 2000 HzDefault Setting: 1000 HzDATA SHIFT (SSB)Function: Sets the carrier point in DATA mode.Available Values: 0 - 3000 HzDefault Setting: 1500 HzDescription: The frequency can be set in steps of10 Hz.LCUT FREQFunction: Sets the low-frequency cutoff audio fil-ter in DATA mode.Available Values: OFF / 100Hz - 1000HzDefault Setting: 300Description: The cutoff frequency can be set at50 Hz increments between 100 Hzand 1000 Hz.88