Yaesu VX-6E Operating Manual

Also see for VX-6E: Operating manual Brochure & specs

Contents

VX-6E O PERATING M ANUAL78MISCELLANEOUS S ETTINGSWAKEUP F EATURE S ETUPThe Wakeup feature is similarly to the Receive Battery Saver. However, it is a newer,more advanced feature which conserves battery life by providing a longer “sleep” timethan the regular Receive battery Saver. The Wakeup feature, once engaged, operates whilethe transceiver is turned off (“WAKEUPWAKEUPWAKEUPWAKEUPWAKEUP” will appear on the LCD).To set up the Wakeup feature:1. Press the [F/W] key, then press the [0(SET)] key to enter the Set mode.2. Rotate the DIAL knob to select Set Mode Item 72: WAKEUPWAKEUPWAKEUPWAKEUPWAKEUP.3. Press the [0(SET)] key momentarily to enable adjustment ofthis Set Mode Item.4. Rotate the DIAL knob to select the desired “sleep” duration.5SEC5SEC5SEC5SEC5SEC/10SEC10SEC10SEC10SEC10SEC/20SEC20SEC20SEC20SEC20SEC/30SEC30SEC30SEC30SEC30SEC:Based on the selected time value, the radio will periodically checkthe operating frequency which it was on when the radio was turned off for activity. Ifa signal is received on the frequency which is strong enough to open the Squelch, theradio will turn itself on fully. If the EAI feature is activated when the radio was turnedoff, the radio also checks on the EAI frequency (Memory Channel “EAIEAIEAIEAIEAI”) for activity.EAIEAIEAIEAIEAI:Checks the EAI frequency (Memory Channel “EAIEAIEAIEAIEAI”) every 5 seconds. If a properly-coded signal is received on the EAI frequency, the radio will turn itself on and thenautomatically transmit in accordance with the setting of Set Mode Item 18: EAIEAIEAIEAIEAI.OFFOFFOFFOFFOFF:Disables the Wakeup feature.5. When you have made your selection, press the PTT switch to save the new settingand exit to normal operation.6. If you wish to disable the Wakeup feature, just repeat the above procedure, rotatingthe DIAL knob to select “OFFOFFOFFOFFOFF” in step 4 above.When the radio is turned off, the Wakeup feature will be engaged,and the “WAKEUPWAKEUPWAKEUPWAKEUPWAKEUP”notition will be been on the display.You may observe a low-level “pop” noise while the Wakeup featureis polling; you may disable this popping by pressing the [MODE(SPS)SQ TYP] key in step 4 above (the “SAVE” notation will disap-pear). However, the battery life will be reduced somewhat.You may cancel the Wakeup feature temporarily by pressing the PWR switch while theWakeup feature is engaged.