VX-6R OPERATING MANUAL 51ALL CH: The scanner sweeps all Preferential Memory channels.TAG1: The scanner sweeps only those Preferential Memory channels with same“first” digit of the alpha/numeric tag as the first channel on which scanningstarted.TAG2: The scanner sweeps only those Preferential Memory channels with same“first” and “second” digits of the alpha/numeric tag as the first channel onwhich scanning started.BAND: The scanner sweeps only those Preferential Memory channels which arememorized on the same operating band as the first channel on which scan-ning started.PMS-X: The scanner will sweep frequencies within the currently-selected PMS fre-quency pair. See page 52 for details.Note: When an alpha-numeric “Tag” is appended to the Low sub-band limitmemory channel, the alpha-numeric “Tag” will appear while you are select-ing the Memory Scan mode.4. Release the [BAND(SCN)BND DN] key to initiate Preferential Memory Scanning.Only the channels which have a blinking “” icon appended to the channel numberwill be scanned.Memory Bank ScanWhen the Memory Bank feature is engaged, the scanner sweeps only memory channels inthe current Memory Bank. However, if the Memory Bank Link Scan feature is enabled,you may sweep the memory channels in several Memory Banks which you have selected.To enable the Memory Bank Link Scan feature:1. Set the radio to the Memory mode by pressing the [V/M(DW)MT] key, if necessary.2. Press the [F/W] key, followed by the [BAND(SCN)BND DN] key to recall the MemoryBank.3. Rotate the DIAL knob to select the first Memory Bank (“BANK 1” ~ “BANK24”) youwish to sweep using Memory Bank Link Scan.4. Press the [V/M(DW)MT] key momentarily. A small blinking “”icon will appear at the left of the Memory Bank number, indicat-ing this Memory Bank will now be swept during Memory BankScan.5. Repeat steps 3 and 4 above, to append the blinking “” icon to any other MemoryBanks you wish to sweep.6. Now, press and hold in the [BAND(SCN)BND DN] key for one second to initiate theMemory Bank Link Scan.7. To remove a Memory Bank from the Memory Bank Link Scan, repeat steps 2 and 3above, to delete the blinking “” icon from the Memory Bank number indication.MEMORY SCANNINGSCANNING