VX-6R OPERATING MANUAL56The Smart Search feature allows you to load frequencies automatically according to whereactivity is encountered by your radio. When Smart Search is engaged, the transceiver willsearch above and below your current frequency, storing active frequencies as it goes (with-out stopping on them even momentarily); these frequencies are stored into a special SmartSearch memory bank, consisting of 31 memories (15 above the current frequency, 15 be-low the current frequency, plus the current frequency itself).Two basic operating modes for Smart Search are available:SINGLE: In this mode, the transceiver will sweep the current band once in each directionstarting on the current frequency. All channels where activity is present will beloaded into the Smart Search memories; whether or not all 31 memories arefilled, the search will stop after one sweep in each direction.CONT: In this mode, the transceiver will make one pass in each direction as with One-Shot searching; if all 31 channels are not filled after the first sweep, however, theradio will continue sweeping until they are all filled.Setting the Smart Search Mode1. Press the [F/W] key, then press the [0(SET)] key to enter the Set mode.2. Rotate the DIAL knob to select Set Mode Item 54: S SRCH.3. Press the [0(SET)] key momentarily to enable adjustment of thisSet Mode Item.4. Rotate the DIAL knob to select the desired Smart Search mode(see above).5. When you have made your selection, press the PTT switch tosave the setting and exit to normal operation.Storing Smart Search Memories1. Set the radio to the VFO mode. Be sure that you have the Squelch adjusted properly(so that band noise is quieted).2. Press and hold in the [MODE(SP S)SQ TYP] key for one second, and rotate theDIAL knob while holding in the [MODE(SP S)SQ TYP] keyto that “S SRCH” indication appears on the display: this acti-vates the Smart Search feature.3. Press and hold in the [BAND(SCN)BND DN] key for one second to begin the SmartSearch scanning.4. As active channels are detected, you will observe the number of “loaded” channelsincreasing in the regular memory channel window.5. Depending on the mode you set for Smart Search operation(“SINGLE” or “CONT”), the Smart Search scan will eventuallyterminate, and the LCD will revert to Smart Search Memory Chan-nel “C.”6. To recall the Smart Search memories, rotate the DIAL knob to choose from among theSMART SEARCH OPERATION