Yamaha DSP-AX3200 Owner's Manual

Also see for DSP-AX3200: Service manual

Contents

20Selecting the OSD Mode1 Turn on the video monitor connected to thisunit.2 Press ON SCREEN on the remote controlrepeatedly to change the display mode.The OSD mode changes in the following order: fulldisplay, short display, and display off.Notes• If you choose a video input source that has a componentconnected to both the S VIDEO IN and composite VIDEO INjacks, and both the S VIDEO OUT and composite VIDEOOUT jacks are connected to a video monitor, the video signal isoutput to both the S VIDEO OUT and VIDEO OUT jacks.However, the OSD is carried only on the S-video signal. If novideo signal is input, the OSD is carried on both the S-videoand composite video signals.• If your video monitor is connected only to the COMPONENTVIDEO jacks of this unit, the OSD is not shown. Make sure toconnect your video monitor to the COMPONENT VIDEOjacks and either VIDEO or S VIDEO jacks if you want to seethe OSD.• Playing back video software that has an anti-copy signal orvideo signals with a lot of noise may produce unstable images.P 0 1 C O N C E R T H A L L 1R O O M S I Z E … … … … 1 . OL I V E N E S S … … … … … … … 5I N I T . D L Y … … … … 3 0 m s≥ E u r o p e H a l l AP 0 1 C O N C E R T H A L L 1E u r o p e H a l l APARAMETERSET MENULEVELON SCREENTESTSLEEPON-SCREEN DISPLAY (OSD)You can display the operation information for this unit ona video monitor. If you display the SET MENU and DSPprogram parameter settings on a monitor, it is much easierto see the available options and parameters than it is byreading this information on the front panel display.y• If a video source is being reproduced, the OSD issuperimposed over the image.• The OSD signal is not output to the OUT (REC) jack, and willnot be recorded with any video signal.• You can set the OSD to turn on (blue background) or off whena video source is not being reproduced (or the sourcecomponent is turned off) by using “13 DISPLAY SET” on theSET MENU (see page 60).OSD ModesYou can change the amount of information the OSDshows.Full displayThis mode always shows the DSP program parametersettings on the video monitor.Short displayThis mode briefly shows the same contents as the frontpanel display at the bottom of the screen and thendisappears.Display offThis mode briefly shows the “DISPLAY OFF” message atthe bottom of the screen and then disappears. Afterwards,no changes to operations appear on the monitor exceptthose of the ON SCREEN button.Full display Short displayy• When you choose the full display mode, INPUT l / h,VOLUME and some other types of operation information aredisplayed at the bottom of the screen in the same format as thatfor the front panel display.• The SET MENU and test tone display appear regardless of theOSD mode.