Yamaha DSP-AX3200 Owner's Manual

Also see for DSP-AX3200: Service manual

Contents

6CONTROLS AND FUNCTIONSTRANSMIT RE-NAMESTANDBY6CH INPUTSOUNDSYSTEMCLEAR LEARN MACRO OFF ONMACROPHONOA BCDDVDVCR2/DVRVCR 1TITLEMENUCHAPTERPAUSESTOPPOWER RECHALL 16.1/ESDSP10KEYROCKCONCERTMOVIETHEATER 1 MOVIETHEATER 2MUTEVOLUMESTEREOTV INPUTTV VOL CHPRESETDISCPARAMETERSET MENUEFFECTLEVELON SCREENTESTSLEEPTV MUTECONCERTVIDEO TVTHEATERENTER-TAINMENTHALL 2 CHURCH JAZZ CLUBSELECT/DTSSUR.CHP/INDEXA/B/C/D/ESELECTDISPLAYSEARCHSOURCEPLAY– +ENTERD-TV/LD CBL/SATCD-RMD/TAPETUNERV-AUXPOWER1596100 10 10011 127 82 3 4++123456780wert9qyuiopdgfsjkhaRemote ControlThis section describes the controls and their functions ofthe remote control. See “REMOTE CONTROLFEATURES” on pages 37 to 49 for operating othercomponents with this remote control.1 Infrared windowOutputs infrared control signals. Aim this window at thecomponent you want to operate.2 RE-NAMEUsed for changing the input source name in the displaywindow (see page 42).3 TRANSMIT indicatorFlashes while the remote control is sending signals.4 STANDBYSets this unit in the standby mode.5 SYSTEM POWERTurns on the power of this unit.6 Display windowShows the selected source component that you arecontrolling.7 SOURCE SELECT k/nSelects the another component to control independentlyfrom the input that has been selected by pressing an inputselector button.8 LIGHTTurns the light on or off. When you press this buttononce, the light turns on for about ten seconds. Press againto turn off the light.9 10KEY/DSPSelects the numeric button (10KEY) mode or DSP mode.0 Operation buttonsProvides functions such as play, stop, skip, etc. foroperating your other components selected by the inputselector buttons.q 6.1/ESTurns on or off the Dolby Digital Matrix 6.1 or DTS ESdecoder with 10KEY/DSP set to the DSP position.w LEVELSelects the effect speaker channel to be adjusted and setsthe level.e ON SCREENSelects the on-screen display (OSD) mode for your videomonitor.r SLEEPSets the sleep timer.t TESTOutputs the test tone to adjust the speaker levels.y CLEARUsed for clearing functions acquired when using the learnand rename features, programmed macros, and setmanufacturer codes (see pages 42 to 44).u LEARNUsed for setting up the manufacturer code or forprogramming the functions of other remote controls (seepages 38 and 39).