Yamaha E40G Service Manual

BRKT7-19 6F65G11Bracket unit2. Assemble the clamp brackets, washers,and swivel bracket, and then install theclamp bracket bolt.3. Install the plate, tighten the self-lockingnuts 1 to the specified torque, and thentighten the cap nuts.4. Install the tilt stopper plate bolts and cir-clips.5. Install the collar 2, and clamp bracketbolt 3, and then tighten the clamp brack-et nuts 4 to the specified torque.Installing the pivot shaft1. Install the straight key 1, bushing 2,and washer 3 onto the swivel bracket 4.2. Place the swivel bracket 4 in an uprightposition, and then install the pivot shaft5 onto the swivel bracket.3. Install the bushing 6, a new oil seal 7,and the washer 8 onto the swivel brack-et.4. Install the dowels 9, steering bracket 0,lower mount clamp q and lower mountcase w onto the swivel bracket. Thentighten the bolt e to specified torque.5. Apply water resistant grease to thegrease nipples.NOTE:Apply the grease until it comes out of thebushings.6780q9we 6F670170Lower mount clamp bolt e:1st:14 N·m (1.4 kgf·m, 10.4 ft·lb)2nd:24 N·m (2.4 kgf·m, 17.7 ft·lb)6F6701757321546F6701606F6701501442 31Self-locking nut 1 :45 N·m (4.5 kgf·m, 33 ft·lb)Clamp bracket nut 4:24 N·m (2.4 kgf·m, 17.7 ft·lb)