Components24EMU26244Trim tab with anodeWARNINGEWM00840An improperly adjusted trim tab couldcause difficult steering. Always test run af-ter the trim tab has been installed or re-placed to be sure steering is correct. Besure you have tightened the bolt after ad-justing the trim tab.The trim tab should be adjusted so that thesteering control can be turned to either theright or left by applying the same amount offorce.If the boat tends to veer to the left (port side),turn the trim tab rear end to the port side “A” inthe figure. If the boat tends to veer to the right(starboard side), turn the trim tab end to thestarboard side “B” in the figure.NOTICEECM00840The trim tab also serves as an anode toprotect the engine from electrochemicalcorrosion. Never paint the trim tab as it willbecome ineffective as an anode.EMU26341Tilt support lever for power trim andtilt modelTo keep the outboard motor in the tilted up po-sition, lock the tilt support lever to the clampbracket.1. Trim tab2. Bolt3. CapBolt tightening torque:42.0 Nm (4.28 kgf-m, 31.0 ft-lb)
