Operation47EMU27872Adjusting trim angle for manual tiltmodelsThere are 4 or 5 holes provided in the clampbracket to adjust the outboard motor trim an-gle.1. Stop the engine.2. Tilt the outboard motor up, and then re-move the trim rod from the clamp brack-et.3. Reposition the rod in the desired hole.To raise the bow (“trim-out”), move the rodaway from the transom.To lower the bow (“trim-in”), move the rod to-ward the transom.Make test runs with the trim set to differentangles to find the position that works best foryour boat and operating conditions.WARNINGEWM00400● Stop the engine before adjusting thetrim angle.● Use care to avoid being pinched whenremoving or installing the rod.● Use caution when trying a trim positionfor the first time. Increase speed gradu-ally and watch for any signs of instabil-ity or control problems. Improper trimangle can cause loss of control.TIP:The outboard motor trim angle can bechanged approximately 4 degrees by shiftingthe trim rod one hole.1. Trim operating angleZMU0264111. Trim rodZMU028901
