PERIODIC MAINTENANCE AND ADJUSTMENT6-356EAU42873Replacing the auxiliary lightbulbIf the auxiliary light bulb burns out, re-place it as follows.1. Remove the headlight unit. (Seepage 6-31.)2. Remove the auxiliary light bulbsocket (together with the couplerand bulb) by turning the socketcounterclockwise.3. Remove the burnt-out bulb by pull-ing it out.4. Insert a new bulb into the socket.5. Install the socket (together with thecoupler and bulb) by pushing it inand turning it clockwise.6. Install the headlight unit.EAU24350Supporting the motorcycleSince this model is not equipped with acenterstand, follow these precautionswhen removing the front and rearwheel or performing other maintenancerequiring the motorcycle to stand up-right. Check that the motorcycle is in astable and level position before startingany maintenance. A strong woodenbox can be placed under the engine foradded stability.To service the front wheel1. Stabilize the rear of the motorcycleby using a motorcycle stand or, ifan additional motorcycle stand isnot available, by placing a jack un-der the frame in front of the rearwheel.2. Raise the front wheel off theground by using a motorcyclestand.To service the rear wheelRaise the rear wheel off the ground byusing a motorcycle stand or, if a motor-cycle stand is not available, by placing1. Coupler11. Auxiliary light bulb2. Auxiliary light bulb socket3. Coupler12 3U39PE0E0.book Page 35 Tuesday, February 16, 2010 9:22 AM
