PERIODIC MAINTENANCE AND ADJUSTMENT6-3765. Pull the wheel axle out, and thenremove the wheel.EAU39401To install the front wheel1. Lift the wheel up between the forklegs.2. Insert the wheel axle.3. Lower the front wheel so that it ison the ground, and then put thesidestand down.4. Install the brake calipers by install-ing the bolts.TIPMake sure that there is enough spacebetween the brake pads before install-ing the brake calipers onto the brakediscs.5. Install the brake hose holders byinstalling the bolt and nut.6. Tighten the wheel axle, the wheelaxle pinch bolt and the brake cali-per bolts to the specified torques.7. Push down hard on the handlebarseveral times to check for properfork operation.EAU25080Rear wheelEAU25313To remove the rear wheelWARNINGEWA10821To avoid injury, securely support thevehicle so there is no danger of itfalling over.1. Loosen the axle nut.2. Lift the rear wheel off the groundaccording to the procedure onpage 6-35.3. Remove the axle nut.1. Brake caliper bolt2. Brake caliper12Tightening torques:Wheel axle:65 Nm (6.5 m·kgf, 47 ft·lbf)Front wheel axle pinch bolt:23 Nm (2.3 m·kgf, 17 ft·lbf)Brake caliper bolt:40 Nm (4.0 m·kgf, 29 ft·lbf)1. Axle nut2. Brake caliper bracket3. Brake caliper123U39PE0E0.book Page 37 Tuesday, February 16, 2010 9:22 AM
