PERIODIC MAINTENANCE AND ADJUSTMENT6-4062. Lift the front wheel off the groundaccording to the procedure in theprevious section “Supporting themotorcycle”.3. Remove the brake caliper on eachside by removing the bolts.NOTICE: Do not apply the brakeafter the brake calipers havebeen removed, otherwise thebrake pads will be forced shut.[ECA11052]4. Pull the wheel axle out, and thenremove the wheel.To install the front wheel1. Lift the wheel up between the forklegs.2. Insert the wheel axle.3. Install the brake calipers by install-ing the bolts.TIPMake sure that there is enough spacebetween the brake pads before install-ing the brake calipers onto the brakediscs.4. Lower the front wheel so that it ison the ground, and then put thesidestand down.5. Tighten the wheel axle, the frontwheel axle pinch bolt and thebrake caliper bolts to the specifiedtorques.6. Push down hard on the handlebarseveral times to check for properfork operation.1. Front wheel axle pinch bolt2. Wheel axle3. Brake caliper bolt3211. Brake caliper bolt2. Brake caliper12 Tightening torques:Wheel axle:65 Nm (6.5 m·kgf, 47 ft·lbf)Front wheel axle pinch bolt:23 Nm (2.3 m·kgf, 17 ft·lbf)Brake caliper bolt:35 Nm (3.5 m·kgf, 25 ft·lbf)
