:_'][_ I'JIF:V4:Y:Te._To select a source connected to the 6CH INPUT jacks, the front panel>Press 6CH INPUT.6CHINPUT% the remote control>Tap Q on the INPUT control panel.@®®®@DVD D-TVILD CABLE SAT VCR1@@@@@¥CR2 ¥CR3iDYR CD MD/TAPE TUNER"6CH INPUT" appears on the front panel display.L, i "i..." i i'.ii..=i i i:.,,::.,,'i i .i,i'il :.,,: i• If "6CH INPUT" is shown on the front panel display, no othersource can be played. To select another input source withINPUT SELECTOR (or one of the input selector buttons onthe INPUT control panel), press 6CH INPUT (or tap O on6CHthe INPUT control panel) to turn off "6CH INPUT" from thefront panel display.• The input source name corresponds to the jack name to whichthe input component is connected. If the component is notconnected to its corresponding jack, input source name andthe playback component do not match. (For example, if a CDplayer is connected to the MD input jack and MD is selectedas an input source, the playback sound will be output from theCD player.) In this case, the input source name can bechanged with "7 INPUT RENAME" on the SET MENU._ Start playback or select a broadcast station on thesource component.Refer to the operation instructions for the component._ Adjust the volume to the desired output level.VOLUME;o.'ff desired, use BASS, TREBLE, BASS EXTENSION andBALANCE. These controls are only effective for sound fromthe main speakers.BASS TREBLE BALANCEBASSEXTENSIONO• If the component connected to the VCR 1 OUT, VCR 2OUT, VCR 3/DVR OUT, CD-R OUT and MDFFAPE OUTjacks is turned off, the reproduced sound may be distorted orthe volume may be lowered for the characteristics of A/Vcomponent. In this case, turn on the component.• While PROCESSOR DIRECT is tuned on, tone controls(BASS and TREBLE) or/and BASS EXTENSION cannotbe activated._ Select a DSP if desired.programPress PROGRAM <#_.PROGRAM I=_ the remote control>Tap on the RECEIVER control panel to open the DSPcontrol panel. Then tap one of the DSP program buttons.See pages to for details about the DSP program.E-44
