Yamaha RX-Z1 Owner's Manual

Also see for CinemaDSP digital RX-Z1: Owner's manual Service manual

Contents

[_o]]COMPLIANCE INFORMATION STATEMENT(DECLARATION OF CONFORMITY PROCEDURE)Responsible Party:Address:Telephone:Type of Equipment:Model Name:Yamaha Electronics Corp.,6660 Orangethorpe Ave.Buena Park, CA90620714-522-9105Remote ControlRAV-2000Z1This device complies with Part 15 of the FCC Rules.Operation is subject to the following conditions:1) this device may not cause harmful interference, and2) this device must accept any interference received including interference that may cause undesired operation.See the user manual instructions if interference to radio reception is suspected.FCC INFORMATION (U.S.A)1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT!This product, when installed as indicated in theinstructions contained in this manual, meets FCCrequirements. Modifications not expressly approved byYamaha may void your authority, granted by the FCC, touse the product.2. IMPORTANT: When connecting this product toaccessories and/or another product use only high qualityshielded cables. Cable/s supplied with this product MUSTbe used. Follow all installation instructions. Failure tofollow instructions could void your FCC authorization touse this product in the USA.3. NOTE: This product has been tested and found to complywith the requirements listed in FCC Regulations, Part 15for Class "B" digital devices. Compliance with theserequirements provides a reasonable level of assurance thatyour use of this product in a residential environment willnot result in harmful interference with other electronicdevices.This equipment generates/uses radio frequencies and, if notinstalled and used according to the instructions found inthe users manual, may cause interference harmful to theoperation of other electronic devices.Compliance with FCC regulations does not guarantee thatinterference will not occur in all installations. If thisproduct is found to be the source of interference, whichcan be determined by turning the product "OFF" and"ON", please try to eliminate the problem by using one ofthe following measures:Relocate either this product or the device that is beingaffected by the interference.Utilize power outlets that are on different branch (circuitbreaker or fuse) circuits or install AC line filter/s.In the case of radio or TV interference, relocate/reorientthe antenna. If the antenna lead-in is 300 ohm ribbon lead,change the lead-in to coaxial type cable.If these corrective measures do not produce satisfactoryresults, please contact the local retailer authorized todistribute this type of product. If you can not locate theappropriate retailer, please contact Yamaha ElectronicsCorp., 6660 Orangethorpe Ave. Buena Park, CA90620.The above statements apply ONLY to those productsdistributed by Yamaha Corporation of America or itssubsidiaries.CAUTION IV