8-10ESU04530Adjusting the throttle cable1. Remove the shroud. (See pages 8-5–8-7 for removalprocedures.)2. Remove the headlight unit bolts and the two topcover bolts near the headlight unit.3. Disconnect the speedometer coupler and headlightcouplers, and then remove the headlight unit.4. Loosen the locknut.5. Turn the adjuster in or out until the proper throttlelever free play is achieved.1 Headlight unit bolt2 Locknut3 Adjuster6. Tighten the locknut.7. Connect the speedometer coupler and headlight cou-plers, and then install the headlight unit, making sureto insert the tabs on the headlight unit stay into theslots on the bottom of the headlight unit.8. Install the headlight unit bolts, and then tighten themto the specified torque.9. Install the top cover bolts.10. Install the shroud.Throttle lever free play a:2.0–3.0 mm (0.08–0.12 in)Headlight unit bolt tightening torque:3 Nm (0.3 m·kgf, 2.2 ft·lb)E_8fp.book Page 10 Tuesday, March 28, 2006 4:35 PM
