Yamaha RX10RX Owner's Manual

Contents

and then push the “SELECT” button for atleast 10 seconds while the snowmobile isstopped.• To switch the barometer display betweenhectopascal “hPa” and inches of mercury“inHg”, select the barometer mode “BARO”,and then push the “SELECT” button for atleast 3 seconds while the snowmobile isstopped.ClockTo set the clock1. Push the “SELECT” button and “RESET”button simultaneously until the hour digitsstart flashing.1 . “SELECT” button2. “RESET” button2. Push the “RESET” button to change thehour setting, and then push the “SE-LECT” button. The minute digits will startflashing.Control functions3. Push the “RESET” button to change theminute setting, and then push the “SE-LECT” button. The clock starts when the“SELECT” button is released.NOTE:The clock must be set again when the batteryis disconnected.Display brightness controlThis function allows you to adjust the bright-ness of the meter display to suit the outdoorlighting conditions.To adjust the display brightness1. Turn the main switch to the off position.2. Push and hold down the “SELECT” but-ton.1 . “SELECT” button2. “RESET” button3. Display brightness level3. Turn the main switch to the on position,and then, after 5 seconds, release the“SELECT” button.4. Push the “RESET” button to select thedesired display brightness level, and thenpush the “SELECT” button. The normaldisplay returns when the “SELECT” but-ton is released.NOTE:If the main switch is turned to the off positionor the engine is started before completing theprocedure, the setting is not applied.13