Yamaha YHT-393 Owner's Manual

Also see for YHT-393: Owner's manual Owner's manual

Contents

En 54SETUPExtended functionality that can be configured as needed (Advanced Setup menu)Avoiding crossing remote controlsignals when using multipleYamaha receiversThe remote control of the unit can only receive signalsfrom a receiver which has an identical ID (remotecontrol ID). When using multiple Yamaha AV receivers,you can set each remote control with a unique remotecontrol ID for its corresponding receiver.On the contrary, if you are setting the same remotecontrol ID for all receivers, you can use one remotecontrol to operate 2 receivers.Initializing various settings for thisunitInitializes various settings stored in this unit and sets itback to default.Select the items to be initialized from the following.iSETUPlNumeric keysnCODE SETSETUP7 85 69 0 101 2 3 4ENTCODE SETRECTVTV VOL TV CHINPUTMUTERECEIVERSCENEOPTIONRETURNVOLUMEENHANCER SUR. DECODESTRAIGHTHDMIAVAUDIOTRANSMITSLEEP1 2 3 41 2 3 41 25V-AUXTUNERFMINFO MEMORYAMPRESET TUNINGMOVIE MUSIC STEREOBDDVD TV CD RADIOMUTEENTERTOPMENU POP-UPMENUDISPLAYSOURCEDOCK[ A ] [ B ]nliID1 (Default) Receives the remote control signals set inID1.ID2 Receives the remote control signals set inID2.ID1 is set for both remote control and receiver bydefault. To avoid crossing remote control, change theremote control ID for both remote control andreceiver.REMOTEID-ID1■ To change the remote control ID1 Press nCODE SET on the remote controlusing a pointed object such as the tip of aballpoint pen.2 Press iSETUP on the remote control.3 Enter the desired remote control ID code.To switch to ID1:Enter “5019” using lNumeric keys.To switch to ID2:Enter “5020” using lNumeric keys.Once the remote control code is registeredsuccessfully the remote control will blink twice.Perform each of the following steps within 1 minute.Settings will be automatically stopped if more than1 minute passes since the last operation. To reset,repeat from step 1.TRANSMITRECEIVERHDMISLEEPSOURCECODE SETRegistration successful: blinks twiceRegistration failed: blinks 6 times• If setup fails, repeat from step 1.• Returns to ID1 after the remote control code isinitialized (☞p. 52).DSP PARAM Initializes all parameters for the soundfield programs.ALL Resets this unit to default factory settings.CANCEL (Default) Does not initialize.INIT-CANCEL