Yazoo/Kees ZCBI48181 Operator's Manual

Yazoo/Kees ZCBI48181 Operator's Manual Manual pdf 27 page image

27SERVICE AND ADJUSTMENTWARNINGBEFORE PERFORMING ANY SERVICEOR ADJUSTMENTS:• Set park brake to engaged position.• Place PTO switch in the disengagedposition (pressed down).• Turn ignition key "OFF" and removethe key.• Make sure the blades and all movingparts have completely stopped.• Disconnect spark plug wire fromspark plug and place the wire whereit cannot come in contact with theplug.MOWERTO LEVEL DECKAdjust the deck while the mower is on a levelsurface. Make sure the tires are inflated to thecorrect pressure (see “SPECIFICATIONS”section in this manual). If tires are under or overinflated, you can not properly adjust your deck.NOTE: It may be easier to adjust the front liftlinkages by removing the floor pan before anyadjustments are madeSIDE-TO-SIDE ADJUSTMENT (See Figs. 13and 14)• Raise the deck into the highest cuttingposition (4 1/2")• Measure height from the bottom edge ofthe deck to the ground at both frontcorners. Distance “A” at both cornersshould be the same.• If adjustment is necessary, makeadjustment to one side the deck only• To raise one side of the deck, using a 9/16"wrench, tighten the hex nuts on both thefrontand rear lift linkages (be sure to tightenequal amounts).• To lower one side of the deck, reverseprevious step.• Recheck measurements afteradjustment.FIGURE 13FIGURE 14HEX NUTFRONT LIFTLINKAGEFIGURE 14AHEX NUTREAR LIFTLINKAGEACZ-16CZ-17CZ-18A