Setting Up Your System35Setting Up Your SystemThis section describes essential information on how to set up your phone network and set up yourphones with a provisioning server. It also provides instructions on how to set up a provisioningserver, how to deploy Yealink IP phones from the provisioning server, how to upgrade firmware,and how to keep user personalized settings after auto provisioning.This chapter provides the following sections: Setting Up Your Phone Network Setting Up Your Phones with a Provisioning ServerSetting Up Your Phone NetworkYealink IP phones operate on an Ethernet local area network (LAN) or wireless network. Localarea network design varies by organization and Yealink IP phones can be configured toaccommodate a number of network designs.In order to get your IP phones running, you must perform basic network setup, such as IPaddress and subnet mask configuration. You can configure the IPv4 or IPv6 network parametersfor the phone. You can also configure the appropriate security (VLAN and/or 802.1Xauthentication) and Quality of Service (QoS) settings for the IP phone.This chapter describes how to configure all the network parameters for IP phones, and itprovides the following sections: DHCP DHCP Option Configuring Network Parameters Manually Configuring Transmission Methods of the Internet Port and PC Port Configuring PC Port Mode Web Server Type Wi-Fi VLAN IPv6 Support VPN Network Address Translation (NAT) Quality of Service (QoS) 802.1X Authentication
