User Guide for the SIP-T40P IP Phone114To retrieve a parked call in Transfer mode:1. Do one of the following:- If the park retrieve code is not configured, dial the park retrieve code (e.g., *11).- If the park retrieve code is configured, press the Retrieve soft key on the dialingscreen or retrieve park key (if configured) on the IP phone.The phone will retrieve the parked call from the shared parking lot.Call PickupYou can use call pickup to answer someone else’s incoming call on your phone. The SIP-T40P IPphone supports directed call pickup and group call pickup. Directed call pickup is used forpicking up a call that is ringing at a target phone number. Group call pickup is used for pickingup a call that is ringing at any phone number in a certain group. The pickup group should bepredefined, contact your system administrator for more information.You can pick up an incoming call by using the DPickup/GPickup soft key. To use call pickup,you need to configure the call pickup code beforehand on a global or per-line basis via webuser interface.NoteDirected Call PickupTo enable directed call pickup and configure the directed call pickup code on a globalbasis via web user interface:1. Click on Features->Call Pickup.2. Select Enabled from the pull-down list of Directed Call Pickup.3. Enter the directed call pickup code in the Directed Call Pickup Code field.4. Click Confirm to accept the change.If there are many incoming calls at the same time, pressing the GPickup soft key on the phonewill pick up the call that rings first.
