Administrator’s Guide for Yealink VC800 Video Conferencing System106To configure SIP IP call via the remote control:1. Select More->Setting->Advanced (default password: 0000)->SIP IP Call.2. Check the SIP IP Call checkbox.3. Select Save, and then press to accept the change.Configuring H.323 SettingsYealink VC800 video conferencing systems support H.323 protocol. If your network uses agatekeeper, you can register an H.323 account for the system, and specify its H.323 name andextension. This allows others to call the system by entering the H.323 name or extension insteadof the IP address.H.323 settings parameters on the system are described below:Parameter Description Configuration MethodH.323 ProtocolEnables or disables the H.323protocol.Default: Enabled.Note: Only when it is set to Enabled,can H.323 account be registered.When it is set to Enabled on bothsites, the VC800 can call the far siteby dialing an IP address directly.Remote ControlWeb User InterfaceH.323 AccountEnables or disables the H.323account.Default: EnabledIf it is set to disabled, the systemcannot place or receive calls with theH.323 protocol.Remote ControlWeb User InterfaceH.323 NameSpecifies the name that gatekeepersand gateways use to identify thissystem. You can make point-to-pointcalls usingH.323 names if both system areregistered to a gatekeeper.Default: blankRemote ControlWeb User InterfaceH.323 ExtensionSpecifies the extension thatgatekeepers and gateways use toidentify this system.Default: blankNote: Users can place point-to-pointRemote ControlWeb User Interface
