User Guide for the W52P IP DECT Phone4Connecting the Base StationYou have two options for power and network connection of the base station. Your systemadministrator will advise you which one to use. AC power Power over Ethernet (PoE)NoteAC PowerTo connect the AC power:1. Connect the DC plug on the power adapter to the DC5V port on the base station andconnect the other end of the power adapter into an electrical power outlet.2. Connect the included or a standard Ethernet cable between the Internet port on the basestation and the Internet port in your network or the switch/hub device port.NotePower over EthernetWith the included or a regular Ethernet cable, the base station can be powered from aPoE-compliant (IEEE 802.3af) switch or hub.Please pay attention to the radio coverage of the base station. It is up to 300m in unobstructedoutdoor areas and up to 50m inside buildings.Do not set up the base station in a damp room, and keep away from the water.The base station should be used with Yealink original power adapter (5V/600mA) only. The use ofthe third-party power adapter may cause the damage to the base station.
