Zanussi CF 50 SI Instruction Booklet

Contents

10If after the above checks, there is still a fault, call your local Service Force Centre.In-guarantee customers should ensure that the above checks have been made as the engineer will make acharge if the fault is not a mechanical or electrical breakdown.Please note that proof of purchase is required for any in-guarantee service calls.Symptom SolutionNo power to applianceThe temperature in the freezer is too highThe freezer door will not openThe compressor runs continuouslyExcessive frost and ice has built up.Noise- Check there is power at the socket.- Check there is not a power cut by checking the household lights.- Check the fuse has not blown.- Check the thermostat control knob is turned to thecorrect setting relative to ambient conditions.- Check the ambient temperature is within the appliancesoperating limits of 10°C to 32°C.Relocate the appliance if necessary.- Has the door just been opened?If so leave for a few minutes to allow the air pressure toequalise.- Adjust the thermostat control knob to give correct tem-perature control. See page 5.- Check that the door is closed.- Large quantities of food have recently been placed inthe cabinet and/or door is frequently opened.- Check that air ventilation is not obstructed.- Ensure the door is not left open.- Check that nothing is preventing the door from closing.Is the door gasket intact and clean?- Has advised periodic defrosting been carried out?- Refer to normal operating sounds.SOMETHING NOT WORKING?Before contacting your local Service Force Centre check the following points.IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use orinstallation, a charge will be made even if the appliance is under guarantee.