Zanussi ZCG667 User Manual

Also see for ZCG667: User manual

Contents

1. Turn the knob to the maximum positionand push it down. When you push theknob, the spark generator activates auto-matically.2. Keep the control knob pushed for approxi-mately 5 seconds. This lets the thermocou-ple warm up. If not, the gas supply is inter-rupted.3. Adjust the flame after it is regular.If after some tries the burner does notlight, check if the crown and its cap are inthe correct positions.756834211 Burner cap2 Burner crown3 Ignition candle4 Thermocouple5 Slots6 Burner body7 Location peg8 HoleReplacing burner parts1. Carefully put the burner crown on theburner body. Do not use force.a) Make sure that the hole in the crown isabove the ignition candle.b) Make sure that the location pegs are inthe slots in the burner body.c) Let the crown fall freely onto the body.d) Make sure that you can move thecrown a small distance from side toside.2. Put the burner cap centrally on top of thecrown (enamel side up). Move the cap fromside to side and front to back to make surethat it is correctly installed.3. Try to light the burner. If the burner doesnot ignite, adjust the crown and cap again.Warning! Do not keep control knobpressed for more than 15 seconds.If the burner does not light after 15 seconds,release the control knob, turn it into off positionand wait for at least 1 minute before trying tolight the burner again.Turning the burner offTo put the flame out, turn the knob to the sym-bol .Warning! Always turn the flame down orswitch it off before you remove the pansfrom the burner.Lid Safety DeviceLid has safety device, which cut off gas supplyfor hob. It works only when lid is closed.Warning! Always use the control knob toswitch off a burner. Do not use the lid as acut-off device.Hob - Helpful hints and tipsWarning! Refer to "Safety information"chapter.Energy savings• If possible, always put the lids on the pans.• When the liquid starts to boil, turn down theflame to barely simmer the liquid.7www.zanussi.com