Zanussi ZDS 679 EX Instruction Booklet

Symptom SolutionThe dishes are not clean n The baskets are too full.(poor wash) n The dishes have not been arranged properly.n The spray arms do not rotate.n The spray arms are clogged.n The filters are clogged.n The filters are not in position.n Not enough detergent has been used or it is unsuitable.n The detergent is old or has gone hard.n The salt container cap is not properly closed.n The washing programme selected is too gentle.Visible lime deposits or white film on n The rinse aid has run out or too little is being used.the dishes Check that there is salt and that the salt cap is tight.The dishes are not quite dry n The dishes have been too long inside the machine.46 PSN09GBIf after all these checks, the problem persists,contact your local Service Force Centre, quotingthe model and serial number. This information canbe found on the rating plate located on the righthand side of the dishwasher door (see picture).Protection against floodingIn order to prevent water floods, the machine hasbeen provided with two additional devices, havingthe following characteristics:1. In the water inlet hose (see Water supplyconnections): the device comes into operationas a result of any damage to the water inlethose and stops the water inflow. It functionseven with the machine off.2. In the bottom of the machine: the device comesinto operation as a result of any water leaks inthe machine and it functions only with themachine on.To repair the machine, call the Service Centre.Service and spare partsThis product should be serviced by anauthorised Service engineer, and onlygenuine spare parts should be used.Under no circumstances should youattempt to repair the machine yourself.Repairs carried out by inexperiencedpersons may cause injury or seriousmalfunctioning. Contact your localService Force Centre.Always insist on genuine spare parts.Prod.No. ........ Ser. No. .........Mod. ........RA01