Zanussi ZDT16002 User Manual

Contents

DA5Put filter (AA) to its initialposition. Make sure that itassembles correctly underthe two guides (DD).6Assemble filters (BB) and(CC). Put them into positionin filter (AA). Turn the han-dle clockwise until itlocks.An incorrect position of the filters can cause badwashing results and damage to the appliance.Cleaning the spray armsDo not remove the spray arms.If the holes in the spray arms are clogged, remove remain-ing parts of soil with a thin pointed object.External cleaningClean the appliance with a moist soft cloth.Only use neutral detergents. Do not use abrasive prod-ucts, abrasive cleaning pads or solvents.TroubleshootingThe appliance does not start or it stops during operation.First try to find a solution to the problem (refer to the ta-ble). If not, contact the Service.With some problems, the display shows an alarm code:• - The appliance does not fill with water.• - The appliance does not drain the water.• - The anti-flood device is on.WWarning! Deactivate the appliance before you makethe checks.Problem Possible cause Possible solutionThe programme does notstart.The mains plug is not connected in themains socket.Connect the mains plug.The appliance door is open. Close the appliance door.The fuse in the fuse box is damaged. Replace the fuse.The delay start is set. Cancel the delay start or wait for the endof the countdown.The appliance does not fillwith water.The water tap is closed. Open the water tap.The water pressure is too low. Contact your local water authority.The water tap is clogged or there is lime-scale on it.Clean the water tap.The filter in the water inlet hose is clog-ged.Clean the filter.The water inlet hose has a kink or abend.Make sure that the position of the hose iscorrect.The anti-flood device is on. There arewater leakages in the appliance.Close the water tap and contact the Serv-ice.24