Problem Possible cause Possible solutionThe appliance does not drainthe water.The sink spigot is clogged. Clean the sink spigot.The water drain hose has a kink or abend.Make sure that the position of the hose iscorrect.After the checks are completed, activate the appliance. Theprogramme continues from the point of interruption.If the problem occurs again, contact the Service.If the display shows other alarm codes, contact the Serv-ice.The washing results and drying results are not satisfactoryProblem Possible cause Possible solutionThe dishes are not clean. The filters are clogged. Clean the filters.The filters are not correctly assembledand installed.Make sure that the filters are correctly as-sembled and installed.The spray arms are clogged. Remove remaining soil with a thin pointedobject.The programme was not applicable forthe type of load and soil.Make sure that the programme is applica-ble for the type of load and soil.Incorrect position of the items in thebaskets. Water could not wash all items.Make sure that the position of the items inthe baskets is correct and that the watercan easily wash all items.The spray arms could not turn freely. Make sure that the position of the items inthe baskets is correct and does not causethe blockage of the spray arms.The quantity of detergent was not suffi-cient.Make sure that you add the correct quan-tity of detergent in the dispenser beforeyou start a programme.There was no detergent in the detergentdispenser.Make sure that you add detergent in thedispenser before you start a programme.Limescale particles on thedishes.The salt container is empty. Make sure that there is dishwasher salt inthe salt container.The set level of the water softener is in-correct.Make sure that the set level of the watersoftener agrees with the water hardness inyour area.The cap of the salt container is loose. Tighten the cap.Whitish streaks and stains orbluish layers on glasses anddishes.The released quantity of rinse aid is toomuch.Decrease the released quantity of rinse aid.25