Zanussi ZDTS401 User Manual

Contents

Zanussi ZDTS401 User Manual Manual pdf 14 page image

Let the dishes cool down before you remove them fromthe appliance. Hot dishes are easily damaged.Standby modeIf you do not switch off the appliance at the end of thewashing programme, the appliance automatically goesinto standby mode. The standby mode decreases en-ergy consumption.Three minutes after the end of the programme, all in-dicator lights go off and the digital display shows onehorizontal bar.Press one of the buttons (not the on/off button), to goback to end-of-programme mode.Care and cleaningWarning! Switch the appliance off before youclean it.Cleaning the filtersImportant! Do not use the appliance without the filters.Make sure that the installation of the filters is correct.Incorrect installation will cause unsatisfactory washingresults and damage to the appliance.1 2Fully clean the filters A, Band C below running wa-ter.3To remove filters B andC, turn the handle ap-proximately 1/4 anti-clockwise.4Remove the flat filter Afrom the bottom of the ap-pliance.5Put the filter system inposition. To lock the filtersystem, turn the handleclockwise until it locks inposition.Important! Do not remove the spray arms.If the holes in the spray arms become clogged, removeremaining parts of soil with a cocktail stick.External cleaningClean the external surfaces of the appliance and con-trol panel with a damp soft cloth. Only use neutral de-tergents. Do not use abrasive products, scouring padsor solvents (acetone, trichloroethylene etc...).Frost precautionsCaution! Do not install the appliance where thetemperature is below 0 °C. The manufacturer isnot responsible for damage because of frost.If not possible, empty the appliance and close the door.Disconnect the water inlet hose and remove water fromthe water inlet hose.14