Zanussi ZFX31400WA User Manual

Also see for ZFX31400WA: User manual

Contents

25www.zanussi.com• Do not damage the refrigerant circuit.• Do not use electrical appliances inside the food storage com-partments of the appliance, unless they are of the type recom-mended by the manufacturer.• Do not use water spray and steam to clean the appliance.• Clean the appliance with a moist soft cloth. Only use neutral de-tergents. Do not use abrasive products, abrasive cleaning pads,solvents or metal objects.• Do not store explosive substances such as aerosol cans with aflammable propellant in this appliance.• If the supply cord is damaged, it must be replaced by the manu-facturer, its service agent or similarlyqualified persons in order toavoid a hazard.Safety InstructionsInstallationWARNING! Only a qualified personmust install this appliance.• Remove all the packaging.• Do not install or use a damaged appliance.• Obey the installation instruction suppliedwith the appliance.• Always be careful when you move the ap-pliance because it is heavy. Always wearsafety gloves.• Make sure the air can circulate around theappliance.• Wait at least 4 hours before connecting theappliance to the power supply. This is toallow the oil to flow back in the compressor.• Do not install the appliance close to radia-tors or cookers, oven or hobs.• The rear of the appliance must standagainst the wall.• Do not install the appliance where there isdirect sunlight.• Do not install this appliance in areas thatare too humid or too cold, such as theconstruction appendices, garages or winecellars.• When you move the appliance, lift it by thefront edge to avoid scratching the floor.Electrical connectionWARNING! Risk of fire and electricalshock.• The appliance must be earthed.• All electrical connections should be madeby a qualified electrician.• Make sure that the electrical information onthe rating plate agrees with the power sup-ply. If not, contact an electrician.• Always use a correctly installed shockproofsocket.• Do not use multi-plug adapters and exten-sion cables.• Make sure not to cause damage to theelectrical components (e.g. mains plug,mains cable, compressor). Contact theService or an electrician to change theelectrical components.• The mains cable must stay below the levelof the mains plug.• Connect the mains plug to the mainssocket only at the end of the installation.Make sure that there is access to the mainsplug after the installation.• Do not pull the mains cable to disconnectthe appliance. Always pull the mains plug.www.markabolt.hu