32www.zanussi.com1. Remove the top hinge cover.2. Unscrew the 2 retaining screws, andremove the hinge from the appliance.112 343. Take the door off.4. Unscrew the two screws fixing the lowerdoor hinge (there is a foot fixing on thehinge, do not remove it from the hinge).Take the door off.125. Then remove the left foot as shown in thefigure.6. Fix the door hinge (with the original footon it) on the opposite side and then theloosened foot at the former place asshown in the figure.Make sure to place the screws in the rightholes as shown in the figure.The edge of thehinge is parallel with the side of the cabinet.Please make sure to place the lowerfoot below the door hinge. The lowerfoot is recognizable by its 4 ribs on theouter surface.7. Fix the door onto the lower hinge pin.8. To fit top door hinge, remove the plasticscrew hole cover carefully, and refit themin the holes left by the hinge retainingscrews.9. Refit the top hinge using the 2 retainingscrews, making sure that the edge ofthe door is parallel with the side of thecabinet.10. Replace the hinge cover.11. Relocate the handle and the plastic plugsto the opposite side.1 2 3WARNING! Reposition, level the ap-pliance, wait for at least four hours andthen connect it to the power socket.Do a final check to make sure that:• All screws are tightened.• The magnetic seal adheres to thecabinet.• The door opens and closes correctly.If the ambient temperature is cold (i.e. inWinter), the gasket may not fit perfectly to thecabinet. In that case, wait for the natural fittingof the gasket.In case you do not want to carry out theabove mentioned operations, contact thenearest After Sales Service Force. The AfterSales Service specialist will carry out thereversibility of the doors at your cost.Electrical connection• Before plugging in, ensure that the voltageand frequency shown on the rating platecorrespond to your domestic power supply.• The appliance must be earthed. The powersupply cable plug is provided with a con-tact for this purpose. If the domestic powersupply socket is not earthed, connect theappliance to a separate earth in compliancewith current regulations, consulting a quali-fied electrician.• The manufacturer declines all responsibil-ity if the above safety precautions are notobserved.• This appliance complies with the E.E.C.Directives.www.markabolt.hu