7The appliance is designed to be connected to 230 Vmonophase electricity supply.The connection must be carried out in compliance withthe laws and regulations in force.Before the appliance is connected:1) check that the main fuse and the domestic installationcan support the load (see the rating label);2) check that the power supply is properly earthed incompliance with the current rules;3) check the socket or the double pole switch used forthe electrical connection can be easily reached withthe appliance built in the forniture unit.The appliance is supplied with a connection cable. Thishas to be provided with a proper plug, able to support theload marked on the identification plate. The plug has tobe fitted in a proper socket.If connecting the appliance directly to the electric system,it is necessary that you install a double pole switchbetween the appliance and the electricity supply, with aminimum gap of 3 mm. between the switch contacts andof a type suitable for the required load in compliance withthe current rules.The connection cable has to be placed in order that, ineach part, it cannot reach a temperature 90 °C higher thanthe room temperature.The brown coloured phase cable (fitted in the terminalblock contact marked with "L") must always be connectedto the network phase.Replacement of the voltage cableOnly cable types H05RR-F, H05V2V2-F T90 or H05 BB-Fmust be used. The cable section must be suitable to thevoltage and the working temperature.The yellow/green earth wire must be approximately 2 cm.longer than the phase wires (Fig. 6).Fig. 6FO 0073NeutralEarth (yellow/green)Electrical ConnectionFig. 5FO 0238YES RIGID COPPER PIPE ORFLEXIBLE PIPE IN STAINLESSSTEEL