Technical specificationsThe technical data is indicated in the rating plate on the left side inside the appliance.38This information can be found on the rating plateinside the cabenit on the left hand wall. Werecommend that you enter this information here, sothat it is handy if needed.If you cannot find the remedy for a malfunction inthese operating instructions, please contact yourdealer or our customer service department andconsult the Guarantee card.Selective ordering of replacement parts can saveunnecessary travel and costs.For this reason always provide the followingappliance information:• Model Name• Model Number (PNC)• Serial Number (S-No.)Customer service and spare partsSomething not WorkingProblems may be due to causes which can easily be solved before calling the Technical Service. Pleasefollow these instructions:Level properly the appliances if it is not well levelled.Weight surpasses the storage limit of the door shelf so spread weight more evenly ortake some products out.The appliance is not properly installed. Please look in the “Building-in” section.Set a lower temperature.Distribute the food products to allow cold air to circulate around them.Make sure that the door is completely closed and that the insulating strip is completeand clean.The temperature where the cabinet is placed is above normal room temperature.Turn the temperature regulator to a warmer setting temporarily.Turn the thermostat knob to a lower number.The temperature where the cabinet is placed is above normal room temperature.Check that the ventilation is sufficient and that the ventilation openings areunobstructed.The cause could be the introduction of large quantities of food and/or frequentopening/closing of the door.Sometimes is normal. During automatic defrosting frost thaws on the cooling plate.Place the drain hose at the back of the cabinet above the drain bowl.Sometimes this is normal. Temperature control may cause clicking sounds when thesystem is connected or disconnected.The injected cooling gas may produce a gurgling sound while passing through thetubes.The motor may cause a humming noise and/or slight bumping.The insulation material used has a tendency to slighly increase noise levels, how ever itallows for much better insulation and a lower energy consumption.Door does not closeIt is too warm inside the refrigeratorIt is too cold inside the refrigerator.The compressor works continuously.There is water inside/outside the refrigerator.Water comes out on the floor.NoisesSYMPTOM SOLUTION