Door reversalThe appliance’s door has been locked in position fortransport by means of pins on both sides. Accordingto the door opening direction, remove relevant pinsat the top and at the bottom.Warning!If the ambient temperature is cold (i.e. inWinter), the gasket may not fit perfectly to thecabinet. In that case, wait for the natural fittingof the gasket or accelerate this process byheating up the part involved with a normalhairdrier.BAInstallationTake utmost care when handling yourappliance so as not to cause any damages tothe cooling unit with consequent possible fluidleakages.• During normal operation, the condenser andcompressor at the back of the appliance heat upconsiderably. Always ensure that there is adequateventilation as a failure to do this will result incomponent failure and possible food loss. Seeinstallation instructions.• Important: if the supply cord is damaged, it mustbe replaced by a special cord or assembly availa-ble from the manufacturer or its service agent.Positioning• Unpack the cabinet and check that it is in goodcondition and free of any transport damage.• The appliance must not be located close toradiators or gas cookers.• Avoid prolonged exposure of the appliance todirect sunlight.• For safety reasons, minimum ventilation must beas shown in Fig.Attention: keep ventilation openings clear ofobstruction.• It is necessary that the niche is provided with aconduct of venti-lation having the followingdimensions:Depth 50 mmWidth 540 mmThe climate classification can be found on the ratingplate, which is located inside the cabinet on the lefthand wall.The following table shows which ambienttemperature is correct for each climate classification:ClimateclassificationSN +10 to +32°C+16 to +32°C+18 to +38°C+18 to +43°CNSTTfor an ambient temperature of50 mmmin.200 cm 2200 cm2min.D52639