CH 12-FOX10:55STEREO3373-OO P E R AT I O N T V F U N DA M E N TA L S P A G E 1 3Introducingyou to thebasics of yourEntertainmentMachine.Basic Television OperationThe source button (TV/VCR/Source) on the remote switches between Videoinput and Cable/Antenna input. On some models A/V input is designatedas a channel that is one below the lowest/one above the highest.You’ll have to use the Channel Up/Down buttons to access it. TheTime/Channel display will read “Video” in place of a channel number.Cable/Antenna Input: This setting allows you to change cable orantenna channels and to view videocassettes on channel 3 (or 4) in monosound.Video Input: This setting allows stereo playback of videocassettes. Thetelevision cannot change channels in the Video mode, but the VCR can.To view the current input source, press ENTER on your remote. TheTime/Channel display should appear in the upper right-hand cor-ner of the screen. If the display reads ‘Video,’ then the source isan A/V input. If the display reads a channel number, then thesource is your Cable or Antenna.CHANNEL UP/DOWN arrows: Use these arrows to change the channels.Auto Program will have found all channels available to you.NUMBER Key Pad: To skip to any channel, enter the number of thechannel using the NUMBER key pad, then press ENTER.FLASHBACK: To instantly return to the last channel viewed,press FLASHBACK.SURF: Switches between the primary channel selection and your cus-tomized surf menus. The surf mode will appear in the lower right cornerof your screen.Volume Right/Left: To adjust the volume level, use the volume Right/Leftarrows. To soften the volume of your TV, press MUTE once. To silence yourTV instantly, press MUTE twice. To get the sound back, press MUTE again.SourceChannel ChangingAudioChannel or Video(Indicates Source)TimeAudio ModeDateThis is an example of the Time/Channeldisplay that appears in the top right andleft corners of your screen.SURF 1DEC/11/98