3373-OI N S TA L L AT I O N S TA N DA R DP A G E 4Connectan off-airantennato yourEntertainmentMachine.Hook Up Your Antenna to the TVMini glossary75 OHM RF CABLE The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wiresticking through the middle, and it screws onto the threaded jack on the back of your TV.300 TO 75 OHM ADAPTER A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an inch longwith two screws on one end and a round opening with a wire sticking out on the other end.RF coaxial wire(75ohm)Antenna TV backTV back panel(expanded view)TV backFlat wire(300 ohm)Antenna300/75 ohmAdapterTV back panel(expanded view)Antenna/CableVideoR LR-Audio L/MonoS-VideoVariableAudio OutAntenna/CableVideoR LR-Audio L/MonoS-VideoVariableAudio OutIf you have a 75 ohm RF cable,then you don’t need any adapters!Remember, when screwing RFcables into jacks, clockwise tight-ens, and counterclockwise loosens.A 300 to 75 ohm adapteris not included with your ZenithEntertainment Machine, but can bepurchased in most consumer elec-tronics stores.back ofremoteHook up your EntertainmentMachine.Remove the back of the remoteand insert two AAA batteries.Plug in your TV into a standard120V, 60 Hz power outlet. Do notplug it into a switched outlet.Go to page 11 to Auto Programyour Entertainment Machine.1234