P A G E 1 8 206-3767EZ Scan (Channel Search)12345Select antenna input,press1. TV/DTV Ant only2. CATV only3. TV/DTV+CATVEZ ScanCh. EditDTV SignalTiltCh. LabelInput SourceSETUPVIDEOAUDIOLOCKSPECIALTIMEMenu Prev.Select antenna input,press1. TV/DTV Ant only2. CATV only3. TV/DTV+CATVCATVCADTVAnt 1Ant 2 XMenu Prev.Select antenna input,press1. TV/DTV Ant only2. CATV only3. TV/DTV+CATVCATVTV/DTVAnt 1Ant 2Menu Prev.Option 1 Option 2 Option 3ENTERENTER ENTERTV/DTVAnt 1Ant 2 X Select cable band,press1. Std2. HRC3. IRCENTERMini glossaryTV The antenna device receiving the program signal sent over-the-air.DTV Digital TV programming sent over-the-air.CATV Your EZ Scan selection, if you subscribe to a cable service.CADTV Your EZ Scan selection, if you subscribe to a digital cable service.*Cable Service Band Note: Select Std=Standard, HRC=HRC Band, or IRC=IRC Band.For further band information, contact your cable service provider.Use EZ Scan to automatically find active channels and store them in the TV’s memoryEZ Scan finds active channels being received by the TV tuner.Cable will not work unless you subscribe to a cable service.Run EZ Scan again after any Antenna/Cable connection changes.Press MENU, (if not selected, use the Up/Down arrow to chooseSetup Menu,) then press ENTER or the right arrow button.Using the Up or Down arrow on the remote control, select EZ Scanon your screen, then press ENTER or the right arrow button.Using the Up or Down arrow, select option 1, 2, or 3. (Based onyour connection(s) to Antenna/Cable 1-2.)Press ENTER to begin the channel search.Note: Allow EZ Scan to complete the channel search cycle for TV,CABLE*, DTV, etc.When the channel search is complete, press MENU repeatedly untilall menus are removed, or press QUIT.PRG POWERCABLE VCR AUX TVSURF-FLASHBK MUTECHANNELCHANNELVOLUME VOLUME1 2 34 5 6708 9MENUREWIND F FWDRECORDENTERSIGNALAUDIOCCQUITSOURCEPAUSE TIMERPLAYSTOPRATIO VIDEO1/51/2/41/2/351/2